4.How to configure
1)Virtual serial port driver installation (required only when you use the USB port on the PC)
-Connect Bluetooth main (master) to USB port of PC (Refer to Attachment 3. Dip switch setting)
-Found New Hardware Wizard detects new hardware by Plug and Play and select Include this location in the search. Then select the folder which contains VirtualCOM_R9032148.
-When installation completes, Found New Hardware Wizard will detects new hardware once again. Then repeat the above setting one more time.
-Refer to Attachment 1.Virtual serial port driver installation.
2)Virtual serial port driver setting (required only when you use the USB port on the PC)
-Check Virtual port and apply the setting as below.
-Start > Control Panel > System > Hardware > Device Manager
-Select USB Serial Port under Port (COM x: Port number varies from your PC condition) and change the Properties.
-Port Setting: 19200, 8, none, 1, hardware
-Advanced Setting: 4096, 4096, 16, 0, 0,
Check in “Serial Enumerator” and “Serial Printer” .
(In case of Win 98, You cannot see “miscellaneous option” Just ignore)
-Make sure not to change COM Port Number (When changes, select the open port)
-Refer to Attachment 2. Virtual serial port setting
3)Bluetooth & Printer dip switch setting
-Set Maser/Slave, Baud rate and handshaking by Dip switch.
-19200 bps, DTR/DSR (RTS/CTS) (Be sure that communication condition must be all the same for PC, Bluetooth master, Bluetooth slave, Printer)
-Refer to Attachment 3. Dip switch setting
4)Bluetooth slave setting
-Connect Bluetooth main (master/slave) to USB (or Serial) port of PC.
-Execute BluetoothConfig_V2.x.exe from the downloaded files.
-Select the virtual port
a)USB port: Select the virtual port (COM x) of step 2).
b)Serial
-Configure Adapter setting: slave, 19200, hardware
-Disconnect the Bluetooth main (master/slave) from the PC, assemble it with the Cover_BT, and connect it to the printer.
-Refer to Attachment 4. Bluetooth slave Setting
V1.00 | WWW.SAMSUNGMINIPRINTERS.COM | 5 |
