S3C2440A RISC MICROPROCESSOR UART
11-5
RS-232C interface
If the user wants to connect the UART to modem interface (instead of null modem), nRT S, nCTS, nDSR, nDTR,
DCD and nRI signals are needed. In this case, the users can control these signals with general I/O ports by
software because the AFC does not support the RS-232C interface.
Interrupt/DMA Request Generation
Each UART of the S3C2440A has seven status (Tx/Rx/Error) signals: Overrun error, Parity error, Frame error,
Break, Receive buffer data ready, Transmit buffer empty, and Transmit shif ter em pty, all of which are indicated by
the corresponding UART status register (UTRSTATn/UERSTATn).
The overrun error, parity error, frame error and break condition are referred to as the receive error status. Each of
which can cause the receive error status interrupt request, if the receive-error-status-interrupt-enable bit is set to
one in the control register, UCONn. When a receive-error-status-interrupt-request is detected, the s ignal causing
the request can be identified by reading the value of UERSTSTn.
When the receiver transfers the data of the receive shifter to the receive F IFO register in FIFO mode and the
number of received data reaches Rx FIFO Trigger Level, Rx interrupt is gener ated. If the Receive mode is in
control register (UCONn) and is selected as 1 (Interrupt request or polling m ode). In the Non-FIFO mode,
transferring the data of the receive shifter to receive holding register will cause Rx interrupt under the Interrupt
request and polling mode.
When the transmitter transfers data from its transmit FIFO r egister to its transmit shifter and the number of data
left in transmit FIFO reaches Tx FIFO Trigger Level, Tx interrupt is generated, if T ransm it m ode in control regis ter
is selected as Interrupt request or polling mode. In the Non-FIFO mode, transferring data from the transmit holding
register to the transmit shifter will cause Tx interrupt under the Interrupt request and polling mode.
If the Receive mode and Transmit mode in control register are selected as the DMAn request m ode then DMAn
request occurs instead of Rx or Tx interrupt in the situation mentioned above.
Table 11-1 Interrupts in Connection with FIFO
Type FIFO Mode Non-FIFO Mode
Rx interrupt Generated whenever receive data reaches the
trigger level of receive FIFO.
Generated when the number of data in FIFO does
not reaches Rx FIFO trigger Level and does not
receive any data during 3 word time (receive time
out). This interval follows the setting of Word
Length bit.
Generated by the receiving holding
register whenever receive buffer
becomes full.
Tx interrupt Generated whenever transm it data reaches the
trigger level of transmit FIFO (Tx FIFO trigger
Level).
Generated by the transmitting holding
register whenever transmit buffer
becomes empty.
Error interrupt Generated when frame error, parity error, or break
signal are detected.
Generated when it gets to the top of the receive
FIFO without reading out data in it (overrun error).
Generated by all errors. However if
another error occurs at the same time,
only one interrupt is generated.