Samsung SCR-3000P user manual 1Check Points before Call Service Center, Trouble Check Points

DIGITAL VIDEO RECORDER

1Check Points before Call Service Center

If the system malfunctions, please check the following instruction before you call the service

center or the shop where you bought the system.

Trouble			Check Points
• Unable to supply power.		– Check the power cable connection behind the sys-
• The POWER LED in front of the system		tem, power supply, and power switch.
remains off and the system is not running
• After power supply, the screen is all black.		– Check the power cable connection of the system and
• After booting, the screen is all blue		monitor and power supply.
		– Check the connection between camera output port
		and system image signal input port and between
		monitor image signal input port and system image
		signal output port.
		– Check the camera output.
		– Check the BNC Cable connected to the system.
• After power supply, no further progress		– Please call the service center or the shop where you
available after booting menu screen		bought the product for investigation or repair.
• No voice		– Check the connection between microphone voice
		output port and system voice signal input port and
		between monitor voice signal input port and system
		voice signal output port.
		– Check the voice signal output.
		– Check the connected cable.
• Unable to record.		– Without input signal, the system can't perform
REC
• The RECORD button (	) can't activate	recording. Please check if the camera output port is
recording.		well connected.
		– As long as the free HDD space ratio remains 0%
		and the FULL indicating LED in front the of system
		remains on, the system will not start recording.
		– To start recording as it is like above, you should set
		the DISK END MODE in the RECORD MODE
		SETUP menu to OVERWRITE and press the
		RECORD / button(	REC
			).
		– To start recording while the DISK END MODE is set
		to STOP, you should set the HDD ERASE in SYS-
		TEM SETUP menu to ON and terminate the menu.
		Then, all the current data will be deleted. Now, you
			REC	) to start
		should press the RECORD button(
		recording. However, as the deleted data can not be
		recovered by all means, you should check again
		before deleting.

Trouble	Check Points
• Abnormal recording and playing after con-	– Check the connection between Multiplexer image
nected to the Multiplexer	output port and system image signal input port and
	between Multiplexer image signal input port and
	system image signal output port.
	– Check the connection between system trigger output
	port(Trigger Out) and Multiplexer.
	– For the details of the Multiplexer, please refer to the
	Multiplexer User's Manual.
• No voice during play	– If the AUDIO RECORD in the RECORD MODE
	SETUP menu is set to OFF, only images will be
	recorded. You should set it to ON to record both
	image and voice.
	– No voice will be supplied to the Still screen or Play
	mode at high or low speed.
• The screen trembles vertically during play.	– Screen trembling often occurs during playing at high
	or low speed, which is a normal symptom.
• The LIVE screen is distorted.	– Appropriate input signals need to be connected for
	each model. Connect NTSC signals to the SCR-
	3000N/SSC-Dual model and PAL signals to the
	SCR-3000P model, otherwise video output may be
	disrupted.
	– Make sure that the path between the remote control
	and the IR sensor is not obstructed. Also, check the
• The remote control does not work.	angle of the remote control with respect to the IR
	sensor and the distance between the remote control
	and the IR sensor.
	– Make sure the remote control's batteries have
	sufficient power.

9-1 9-2