Samsung SCX-4521FG manual ID Card Copying, Up or 4 Up Copying, Poster Copying

5If necessary, customize the copy settings, including number of copies, darkness, and original type, by using the control panel buttons. See “Setting Copy Options” on page 4.3.

NOTE: You cannot adjust the copy size using the Reduce/ Enlarge button while Auto Fit copying is enabled.

6Press Start to begin copying.

ID Card Copying

You can copy both sides of the ID Card like a drivers licence to a single side of paper.

When you copy using this feature, the machine prints one side

of the card on the upper half of the paper and the other side on

the lower half without reducing the size of the original.

If the loaded card is larger than the printable area, some portions may not be printed.

This special copy feature can be applied only when you place a document on the document glass. If a document is detected in the ADF, ID Card copying feature does not work.

1Place the ID Card to be copied on the document glass and close the cover.

2Press Menu until “Copy Feature” appears on the top line of the display.

3Press the scroll button ( or ) until “ID Card Copy” displays on the bottom line.

4Press Enter to make your selection.

5If necessary, customize the copy settings, including number of copies, darkness, and original type, by using the control panel buttons. See “Setting Copy Options” on page 4.3.

6Press Start to begin copying.

Your machine begins scanning the front side.

7When “Set Backside” displays on the bottom line, open the document cover and turn the card over. Close the cover.

NOTE: If you press the Stop/Clear button or if no buttons are pressed for approximately 30 seconds, the machine cancels the copy job and returns to Standby mode.

8Press Start again.

			2 Up or 4 Up Copying
			This copy feature is available only when you load documents in
	2
			the ADF.
			1	Load the documents to be copied in the ADF.
	1
2-up copying 2				Press Menu until “Copy Feature” appears on the top line of
			3	the display.
	1	2		Press the scroll button ( or ) until “2 UP” or “4 UP”
				displays on the bottom line.
	3	4	4	Press Enter to make your selection.
			5	If necessary, customize the copy settings, including

4-up copying number of copies, darkness, and original type, by using the control panel buttons. See “Setting Copy Options” on page 4.3.

NOTE: You cannot adjust the copy size using the Reduce/ Enlarge button for making a 2 or 4 Up copy.

6Press Start to begin copying.

Poster Copying

This special copy feature can be applied only when you place a document on the document glass. If a document is detected in the ADF, the Poster copying feature does not work.

1Place the document to be copied on the document glass and close the cover.

2Press Menu until “Copy Feature” appears on the top line of the display.

3 Press the scroll button ( or ) until “Poster” displays on the bottom line.

4Press Enter to make your selection.

5If necessary, customize the copy settings, including number of copies, darkness, and original type, by using the control panel buttons. See “Setting Copy Options” on page 4.3.

NOTE: You cannot adjust the copy size using the Reduce/ Enlarge button when making a poster.

6Press Start to begin copying.

Your original document is divided into 9 portions. Each portion is scanned and printed one by one in the following order:

4.5 Copying