Digital Multiplexer
Chapter 4. Basic Method to use
Initial operation
1. Turn on power switch.
A
(The current operation status is memorized when the power turns off after completing the initial set- ting and thus the unit operates in the operation status when the power turns off if turning power on.)
2. Setup a recording channel.
Set the channel without inputting to “off” in the “DUTY SET” of “1.REC OUT SET” on the program menu.
3.Change it to a desiring indication mode.
-Indication of FULL screen: The selected channel is indicated on monitor in the form of FULL channel.
-Indication of division screen: The division screen is indicated on monitor if pressing the multi- screen button. Resetting channel is available for the division screen if user wants.
-Indication of automatic sequential conversion: The full screen is automatically converted if press- ing the sequence button.
-Indication of stop screen: A desired channel can be seen in a form of stop screen using the freez- ing button and camera selection button.
-Indication of live/P.B: The current camera signal may be monitored or the recorded screen may be reproduced for a view using the live/P.B button.
-Indication of TRIPLEX screen: The current camera signal and the recorded screen may be seen on the same monitor using the TRIPLEX button.
-Indication of PIP screen: The PIP (picture in picture) screen may be seen using the PIP button.
-Indication of expansion screen: The full screen may be expanded up to 4 times for view using the zoom and move button.
-Indication of record check screen: The recorded output screen or the output screen of VCR may be seen using the REC CHECK button.
When desiring to see in the live screen/replay screen
The “live/P.B” select button determines the live screen/replay screen mode. The LED turns on in the live mode and it turns off in the tape replay mode.
If pressing this button, the indication mode is changed to the replay mode for the live mode and to the live mode for the replay mode.
➢The “LIVE/P.B” button does not operate in the following cases:
-During zoom operation
-In setting of program mode
-In displaying ALARM/LOSS LIST on screen
When desiring to see in the TRIPLEX screen
The “TRIPLEX” button sets the TRIPLEX screen mode. In this case the LED turns on and the previous TRIPLEX division mode is set.
➢The “TRIPLEX” button does not operate in the following cases:
-During zoom operation
-In setting of program mode
-In displaying ALARM/LOSS LIST on screen
ENGLISH
