English
6-2
●Other PTZ device Control Modes perform its control in a single screen. Press the
channel selection button in the left front to select the channel whose Menu
selected PTZ and then press the PTZ button. If you succeed in entering Single
Screen PTZ device Control Mode, the PTZ symbol on the screen will turn yellow
from white while the PTZ button will turn blue. Single Screen PTZ device Control
Mode supports Pan, Tilt, and Zoom operation basically and Preset, Camera Menu,
and other functions additionally.
●Press the PTZ button in Live Mode to cancel PTZ device Control Mode. After
cancellation, the PTZ symbol on the screen will turn white from yellow while the
PTZ button will lose its blue light.
●When using a remote control device (SCC2000), you may perform camera control
from the remote control device (limited to Samsung Protocol). (Refer to SCC2000
User’s Manual.)
The PTZ Mode will be automatically when there is no PTZ control in the DVR for
up to 5 minutes. This is to enable the PTZ control from the remote Viewer when
there is no PTZ control.
1
PTZ device Control Mode
6-1
●Select a proper PTZ Device Configuration value in MENU to enter PTZ Control
Mode.
●Selected in MENU, the symbol( ) of PTZ is displayed on the channel in the
screen.
●If you press the Enter( ) button among direction keys in front of Split Screen,
a blue bar will appear in the monitor screen. Use direction keys to move this bar
until you reach the channel with the PTZ symbol and press the PTZ button in front
of SHR-4081N/P to enter PTZ device Control Mode.
If you succeed in entering PTZ device Control Mode, the PTZ symbol on the
monitor screen will turn yellow from white while the PTZ button in front of
SHR-4081N/P will turn blue. PTZ device Control Mode supports Pan, Tilt, and
Zoom operation.
SHR-4081N/PUSER’S MANUAL
PTZ
¦
PTZ
TELE WIDE VIEW
PRESET
Note
Note
If you select Remote Control Device, you may not control PTZ device with SHR-
4081N/P. It’s because the PTZ button in front of SHR-4081N/Premains inactivated.
Press the PTZ button and the PTZ ban icon( ) will appear. It’s because the
RS-485 port setup was done for Romote Control Device.
Some functions of PTZ camera may not be used for SHR-4081N/P.
English