Samsung SID-600P manual Adjust the Lens direction and assemble the Dome Cover

00356A SID-600P-eng 12/10/02 12:14 PM Page 20

Installing the Camera

7) Route the cables through the PIPE assembly hole on the side of the PIPE,

align the INDEX KEY arrow mark ( ) of the CAMERA body to the groove on the CAMERA, mount the CAMERA body and turn it clockwise all the way tight, and then fasten the two SCREWS.

E

8) Use a “minus” screwdriver or a coin to turn the CAP BOLT clockwise to fasten it to the PIPE assembly hole at the bottom of the CASE. (Make sure that an O RING (P22 T2.4) is inserted into the CAP-BOLT. If the O RING is not inserted, it will not be waterproof and cause damage to the product.)

9) After arranging the connected power cable and video cable inside the PIPE and then pulling them out, put together the CAMERA’s PIPE assembly screw (3/4” Threaded) and the PIPE’s screw

(3/4” Threaded) to fasten the SET.		E
(*Wrap a TEFLON TAPE around the
threaded area of the PIPE to make the
connection watertight, and make sure
that the cables are not caught by the
fastening area.)
10) Adjust the LENS direction and assemble the DOME COVER.
(Refer the steps 6 to 8 of the ceiling installation for LENS adjustment and
DOME COVER assembly.)
➣ How to switch the top and bottom of the screen if	180º
installing the DOME COVER facing up Loosen the
STOPPER-RING, remove the COVER-LENS, and
rotate the LENS body 180 degrees so that the
BOTTOM mark is pointing downward. Put the
COVER-LENS back on, position the LENS in the
direction you want, and then turn the STOPPER-
RING clockwise to tighten it.

20 21