Transmission

2-7

2-8

2400 baud

ON

ON

4800 baud

OFF

ON

9600 baud

OFF

OFF

19200 baud

ON

OFF

*1) : It may use in dark area. (like a restaurant). But printing speed to be slow down.

*2) : Enalbe = Automatically print NV bit image #1 after cutting.

*3) : EPSON Kitchen Printer mode : A alarm is generated by printer after auto-cutting and in paper-end error. (It needs buzzer accessory)

Notice

Changes in DIP switch settings are recognized only when the printer power is turned on or when the printer is reset by using the interface. If the DIP switch setting is changed after the printer power is turned on, the change does not take effect until the printer is turned on again or is reset.

19

3-2. Changing the DIP switch setting

If you need to change settings, follow the steps below to make your changes.

CAUTION

Turn off the printer before removing the DIP switch cover to prevent an electric short, which can damage the printer.

1)Make sure the printer is turned off.

2)Remove the screw from the DIP switch cover.

Then take off the DIP switch cover, which is shown in the illustration below.

3)Set the switches using a pointed tool, such as tweezers or a small screwdriver.

4)Replace the DIP switch cover. Then secure it with the screw.

*The new settings take effect when you turn on the printer.

20

Page 14
Image 14
Samsung SRP-500 manual Changing the DIP switch setting