Samsung SRP-500 ① GS V m ② GS V m n, GS a n, Name Enable/Disable Automatic Status Back Format

①GS V m

② GS V m n

[Name]			Feeds paper for cutting position.
[Format]			① 1 ASCll	GS	V	m
			Hex	1D	56	m
			Decimal	29	86	m
			② ASCll	GS	V	m	n
			Hex	1D	56	m	n
			Decimal	29	86	m	n
[Range]			① m = 1, 49		② m = 66, 0 ≤ n ≤ 255
[Description]			Feeds paper for cutting position as follows;
Bit					Print mode
1, 49	Partial cut (one portion left uncut)
66		Feeds paper for ( cutting position + [n x 0.122 mm {1/192 inches}]), and partial cut.

[Notes]

•This command is effective only at the beginning of a line.

•When n = 0, the printer feeds the paper to the cutting position.

•When n , 0,the printer feeds the paper to (cutting position +[ n x 0.122 mm {1/192 inches}]).

GS a n

[Name]	Enable/Disable Automatic Status Back
[Format]	ASCII	GS	a	n
	Hex	1D	61	n
	Decimal	29	97	n
[Range]	0 ≤ n ≤ 255
[Description]	Enables or disables ASB and specifies the status items to
	include, using n as follows:

63

Bit	Off/On	Hex	Decimal	Status for ASB
0	Off	00	0	Drawer kick-out connector pin 3 status disabled.
	On	01	1	Drawer kick-out connector pin 3 status enabled.
1	Off	00	0	On-line/off-line disabled.
	On	02	2	On-line/off-line enabled
2	Off	00	0	Error status disabled.
	On	04	4	Error status enabled.
3	Off	00	0	Paper roll sensor status disabled.
	On	08	8	Paper roll sensor status enabled.
4	-	-	-	Undefined.
5	-	-	-	Undefined.
6	-	-	-	Undefined.
7	-	-	-	Undefined.

[Notes]

•Even if only one of the statuses is enabled, the status is sent when this command is executed. Subsequently, whenever the state of a valid status changes, that status is sent. In this case, because the current state is shown for each status, there is a possibility of a state change for a status for which ASB is not enabled.

•If all statuses are disabled, the Automatic Status Back (ASB) function is disabled.

•When transmitting a status, the printer transmits only four bytes.

•Four bytes of status data must be consecutive, except for XOFF code.

•This command is executed when the data in the receive buffer is developed. Therefore, there may be a time lag between receiving this command and transmitting the status, depending on the receive buffer status.

•When the printer is disabled by ESC = (Select peripheral device), this command is disabled but ASB is not disabled.

•The status to be transmitted are as follows:

64