Setting Up Option Switches (Cont.)
Original Position of Option Switches
The option switches are preset by the manufacturer. Refer to the table below, if necessary.
Option Place | Component No. | State | |
Main PCB in the | Rotary Digital Switch(SW1) | 0 | |
DIP Switch(SW2) | ON | ||
indoor unit | |||
|
| ||
| Jumper Wire(SW05) | SHORT | |
Sub PCB in the indoor unit | CN20 Connector | Connected | |
Wired Remote Controller | DIP Switch(DS01) | OFF | |
Centralized Controller | DIP Switch(DS01) | OFF | |
Transmitter | Rotary Digital Switch(DS01) | 0 |
Note ◆ Before setting up the options, always make sure that you have switched off the main power.
◆After adjusting the options, you should supply the power. Otherwise, the options will not be applied.