maintenance
To reduce the risk of injury from moving parts, turn off vacuum cleaner and disconnect WARNING Power Plug from electrical outlet.
CHECK BRUSH DRUM AND DRIVE BELT
You should check your vacuum cleaner’s Brush Drum and Drive Belt regulaly for wear or damage. You should also clean the brush ends of strings, hair, and carpet fibers. These can wrap around the brush and hamper its ability to effectively clean your carpet. Also remove and debris that has accumulated under the brush cover.
1.Unplug cleaner from electrical outlet.
2.Place handle in low position and turn vacuum cleaner over so bottom side is up.
3.Remove the six screws as shown with a screwdriver.
4.Grasp Brush Drum at both ends and lift.
5.Clean strings, hair and other debris from Brush Drum, paying particular attention to brush ends.
Brush Cover
6.Clean strings, hair and other debris from Motor Shaft and Drive
Belt areas.
7.Check Drive Belt carefully for wear, cuts or stressed areas.
8.Check Air Passageway for obstructions. Remove debris from this area.
Air Passageway |
REPLACE BRUSH DRUM AND DRIVE BELT
1.Unplug cleaner from electrical outlet.
2.With Brush Drum removed from vacuum cleaner (Step
3.Place new Belt over Motor Shaft and stretch other end over Brush Drum in the space between the bristles.
4.Place ends of Brush Drum down into slots on sides as shown.
5.Turn Brush Drum by hand several times in the direction of Motor Shaft. If properly installed, Drive Belt will center itself on Rotating
Brush.
6.Reposition Brush Cover and screw or snap back into place. Check to be sure all screws or latches are secured.
Motor Shaft
Drive Belt
①
③
② 
12_ maintenance
