Sanyo DSR-M manual Connecting cables to the control and alarm terminals, Connecting to a network

3 INSTALLATION AND CONNECTIONS

zConnect the cable of the wired remote control (VA- RMN01) (sold separately) to the remote control input terminals (among the control terminals).

Cut the plug off the cord, and connect the red wire to “REMOTE” and the bare wire to “C”.

RS485	REMOTE
A B C		C

Red wire Bare wire

White wire

VA-RMN01

Connecting cables to the control and alarm terminals

(1)Push in the lock pin with a flat-blade screwdriver.

(2)Insert the cable.

(3)Pull out the lock pin with a flat-blade screwdriver. The cable is now fixed in place.

Cable

Flat-blade screwdriver

Connecting to a network

The VA-SW81LITE/VA-SW814 application software lets you control the digital video recorder, and monitor live images, recorded images and audio through a network.

PC

PC

SWITCH

SWITCH SWITCH SWITCH SWITCH

DVR DVR DVR DVR

Connecting the power cord

1 When you have finished making all the other connections, insert the power plug into the wall outlet.

There is no power switch. The POWER indicator lights, then all the indicators on the front panel flash for approximately 30 seconds. The monitor screen displays the camera image.

LAN

OUT	MIC IN	IN	OUT	TV SYSTEM
				NTSC
				PAL

ALL

RESET

*	Attach the supplied ferrite
	core to the base of the power
*	cable (coiling not necessary).

zWhen turning the power ON for the first time “PLEASE SET THE CLOCK” is displayed on the monitor screen. Follow the steps on P.12 to set the clock.

z If the clock is	Operation display area
already set
The operation display
	HI	A
area is displayed.	20-05-04 AL	00015
	08:30:45 ----------

zIf the POWER indicator flashes

The digital video recorder has a self-check function that detects problems. If there is a problem at power ON or during operation, the type of problem is indicated by how rapidly the POWER indicator flashes. Contact a Sanyo Authorized Service Center if the POWER indicator flashes.

4 flashes per second:

The hard disk is checked automatically at power ON. If a hard disk problem is found, the POWER indicator flashes, and the hard disk must be replaced or initialized. If you need to save images stored on the disk, contact a Sanyo Authorized Service Center.

1 flash per second: Fan problem

zIf you disconnect the power cable

Don’t move the digital video recorder for 30 seconds after power OFF.

The disk in the hard disk drive briefly keeps spinning after power OFF due to inertia, during which time the head is unstable. At this time, the disk is sensitive to shocks or vibrations, so avoid even light shocks.

INTRODUCTION

10 English