Sanyo MDF-U730M instruction manual Defrosting, Maintenance

DEFROSTING

Use the scraper provided for removing the frost if the freezer operation must be continued. Pay attention not to impact or damage the inner wall.

1.When defrosting, move all the contents of containers in the freezer to another low temperature freezer.

2.Pressing the DEF key for more than 5 seconds to stop the refrigerating operation.

While the refrigerating operation is stopped, the current chamber temperature and dF is displayed on the control panel alternately.

3.After a several hours, check the visually that all defrost was removed completely.

4.If a defroster is finished, a drain cap at bottom inside the freezer is removed. Draw drain hose, and drain the water with water inside the freezer in the tray. Wipe the water left in the freezer, and do the cap.

5.Pressing the DEF key for more than 5 seconds, the refrigerating operation can be started.

6.Once the chamber temperature has dropped to the desired temperature, place the original contents back in the freezer chamber.

Note: After the defrosting, the refrigerating is never resumed automatically.

Make sure to press the defrost key (DEF) for more than 5 seconds to start operation again.

MAINTENANCE

WARNING

Always disconnect the power supply to the unit prior to any repair or maintenance of the unit in

order to prevent electric shock or injury.

Ensure you do not inhale or consume medication or aerosols from around the unit at the time of

maintenance. These may be harmful to your health.

CAUTION

Always put on the dry gloves to protect the hands at the time of maintenance. No gloves may cause

cut of the finger by the edge or corner.

Cleaning

￭Clean the unit once a month. Regular cleaning keeps the unit looking new.

￭Use a dry cloth to wipe off small amounts of dirt on the outside and inside of the unit and all accessories. If the outside panels are dirty, clean them with a diluted neutral dishwashing detergent. (Undiluted detergent can damage the plastic components. For the dilution, refer to the instruction of the

detergent.) After the cleaning with the diluted detergent, always wipe it off with a wet cloth. Then wipe off the cabinet or accessories with a dry cloth.

￭Never pour water onto or into the unit. Doing so can damage the electrical insulation and may cause electric shock or short circuit.

￭The compressor and other mechanical parts are completely sealed. This unit requires absolutely no lubrication.

17