Setting

On start

On start

When this function is “On”, the projector is automatically turned on just by connecting the AC power cord to an outlet.

✔Note:

•Be sure to turn the projector off properly (see “Turning Off the Projector” on p. 20). If the projector is turned off in the incorrect sequence, the On start function does not operate properly.

Lamp control

You can change the brightness of the screen.

Normal ....

Normal brightness

 

 

 

Auto ........

Brightness according with the input signal

Eco ..........

Lower brightness reduces the lamp power

 

consumption

and

extends

the

 

lamp life.

 

 

 

Remote control

 

 

Remote control

This projector provides two different remote control codes; the factory-set, initial code (Code 1) and the secondary code (Code 2). This switching function prevents remote control interference when operating several projectors or video equipment at the same time.

When operating the projector in “Code 2”, both the projector and the remote control must be switched to “Code 2”.

To change the code for the projector;

Select either “Code 1” or “Code 2” in this Setting Menu.

To change the code for the remote control;

Press and hold both the MENU and IMAGE buttons together for 10 seconds or more. After changing the code, make sure the remote control operates properly.

✔Note:

•When different codes are set on the projector and on the remote control, any operation cannot be made. In that case, switch the code on the remote control to fit the code on the projector.

•When the batteries of the remote control are replaced, the remote control code automatically returns to the initial code (Code 1).

Press and hold MENU and IMAGE buttons for 10 seconds or more.

46