Use of telnet
3.When communication is established correctly, the word "PASSWORD:" appears on the window. Type the login password (Network PIN code*2) for the projector and then press "Enter" key on the keyboard. If you do not set up the Network PIN code, just press "Enter" key.
When the word "Hello" is replied, login has been succeeded.
*The password "1234" is used for the example.
4.Type the commands, refer to below table, to control the projector and then press "Enter" key for termination. For example, type "C00" which is a command to turn on the projec- tor, and press "Enter" key. Confirm the projector is turning on.
*Enter with ASCII
To disconnect the communication, press "Ctrl" key and "]" key at the same time, type "close" and then press "Enter" key on the Keyboard.
> close [return]
The table below shows the typical command lists for controlling this projector and please consult your local dealer for further information of another commands.
Command list table
Command | Function |
| |
| C00 | Power on |
|
| C02 | Power off |
|
| C09 | Volume up |
|
| C0A | Volume down |
|
| C0B | Audio Mute on |
|
| C0C | Audio Mute off |
|
| C1C | Menu display on |
|
| C1D | Menu display off |
|
|
|
|
|
*1 Further instructions about the telnet application, please see the
disconnected automatically. Please try again for the connection.
✐If the password or any command is not entered for more than 30 seconds, the communication will be disconnected automatically. Please try again for the connection.
ENGLISH
49
