
Setting
Lamp counter reset
This function is used to reset the lamp replace counter. When replacing the projection lamp, reset the lamp replace counter by using this function. See page 51 for operation.
Factory default
This function returns all setting values except for the lamp counter to the factory default settings.
Cleaning
This function is used to clean inside of the projector. Using blower at the same time is more effective. (See p48)
Press the SELECT button, then the projected image is blacked out temporary whether input source is selected or not. The fan starts to move automatically to help blowing the dust.
To restore to normal, press any other buttons.
To cancel, press any other button during the cleaning operation.
Panel adjustment
This function is used to get the best picture reproduction of each of the R(red), G(green) and B(blue) LCD panels. If proper adjustment is not made, you might get vertical noise lines on the screen.
This function should be made about ten minutes after turning on the projector, with any signals or without a signal.
Darker environment makes your adjustment more accurate.
The Test pattern screens appear in the order of red, green, blue. Adjust each patterns as follows.
1.Adjust Bright dialog to minimize vertical lines in the bright part of the picture.
2.Adjust Dark dialog to minimize vertical lines in the dark part of the picture.
3.Press the Point Up/Down button to get to the next color. Repeat 1 and 2 for each of R,G,B panels until lines of the picture are minimized.
4.Press the Point Up/Down button to get to the Check pattern screen and check adjustment.
5.To close this screen, press MENU.
Factory default
Select Factory default and this box appears. Select [Yes] , and the next box appears.
Select [Yes] to activate it.
1.Adjust bright parts with the bright dialog.
2.Adjust dark parts with the dark dialog.
3.Then adjust Test pattern G and Test pattern B in the same way.
4.Check adjustment with Check pattern screen.
NOTE
●When Panel adjustment is selected, Power management cannot be selected.
44