
Maintenance and Cleaning
Lamp Replacement
When the life of the projection lamp of this projector draws to an end, |
|
the LAMP REPLACE indicator lights yellow. If this indicator lights | Top Control |
yellow, replace the lamp with a new one promptly. |
|
| POWER |
This indicator lights yellow | WARNING |
when the life of the projection |
|
lamp draws to an end. | LAMP |
| |
| REPLACE |
CAUTION
Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot.
CAUTION
For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.
|
|
| Screw | Lamp Cover |
Follow these steps to replace the lamp. |
|
|
| |
1 | Turn off the projector and disconnect the AC plug. Allow the |
|
|
|
| projector to cool for at least 45 minutes. |
|
|
|
2 | Turn over the projector. Loosen the screw with a screwdriver, |
|
|
|
| and remove the lamp cover. |
|
|
|
3 | Loosen 2 screws of the lamp with a screwdriver and pull out the |
|
|
|
| lamp by grasping the handle. |
|
|
|
4 | Replace the lamp with a new one and tighten the 2 screws back | Lamp |
|
|
| into position. Make sure that the lamp is set properly. Replace | Screw |
| |
| the lamp cover and tighten the screw. |
|
| |
|
|
|
| |
5 | Connect the AC power cord to the projector and turn on the |
|
|
|
| projector. |
|
|
|
6 | Reset the Lamp replace counter. |
|
| Handle |
|
|
| ||
| See “Lamp Replace Counter” on the next page . |
|
|
|
Screw
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.
● | Model No. of your projector | : | |
● | Replacement Lamp Type No. | : | |
|
|
| (Service Parts No. 610 317 5355) |
50