
Maintenance and Cleaning
Cleaning the Air Filter
The air filters prevent dust from accumulating on the surface of the optical elements inside the projector. Should the air filters become clogged with dust particles, it will reduce cooling fans’ effectiveness and may result in internal heat build up and adversely affect the life of the projector. Clean the air filters according to the following steps below.
1 | Turn off the projector and disconnect the AC power cord from |
| the AC outlet. |
2 | Turn over the projector. Put the projector on a soft cloth not to |
| scratch the surface. |
Cleaning the Air Filter 1
3 | Push the latch and lift the air filter. Do not try to pull the delicate |
| filter part. |
4 | Pull the Air Filter horizontally not to break the inside latch. |
5 | Remove dust and dirt with a soft brush or vacuum cleaner. Be |
| careful not to damage the air filter and do not clean the air filter |
| with water. Clean the air intake vent with a vacuum cleaner at |
| the same time. |
6 | Put the air filter back into the position with pushing the top of |
| the tub. Do not push the delicate filter part. Make sure that the |
air filters are properly and fully inserted.
Air Filter 1 |
|
(Intake Vent) | Air Intake Vent |
Air Filter 2
3Press here(the latch)
4
6w Push here
q Put the latch in the groove
q | w Push the top of the tab |
Cleaning the Air Filter 2
3 | Pull the latches on both edges upward. |
| |
4 | Remove dust and dirt with a soft brush or vacuum cleaner. Be |
careful not to damage the air filters and do not clean the air | |
| filters with water. When there is much dust and dirt on the air |
| filter, replace it with a new one. (See next page for replacing |
| the air filter. ) |
5 | Put the air filters back into position. Make sure that the air |
filters are properly and fully inserted. |
Air Filter 2
Latch
CAUTION
Do not operate the projector with the air filter removed. Dust may accumulate on the LCD panel and the projection mirror degrading picture quality.
Do not put small parts into the air intake vents. It may result in malfunction of the projector.
RECOMMENDATION
We recommend avoiding dusty/smoky environments when operating the projector. When using under dusty or smoky conditions, dust may accumulate on a lens, LCD panels, or optical elements inside the projector. This condition may degrade the quality of a projected image.
When the above symptoms are noticed, contact your authorized dealer or service station for proper cleaning.
48