Sanyo SCP-6400 manual Displaying Your Phone Number, Making and Answering Calls, Making Calls

Charging the Battery

Your PCS Phone comes with a rechargeable battery. You should charge the battery as soon as possible so you can begin using your phone.

Keeping track of your battery’s charge is important. If your battery level becomes too low, your phone automatically turns off and you will lose all the information you were just working on. For a quick check of your phone’s battery level, glance at the battery charge indicator located in the upper-right corner of your phone’s display screen. If the battery charge is

getting too low, the battery icon appears and the phone sounds a warning tone.

Always use a Sprint-approved desktop charger, travel charger or vehicle power adapter to charge your battery.

Warning! Using the wrong battery charger could cause damage to your phone and void the warranty.

Using the Travel Charger

To use the travel charger provided with your phone:

Use only an approved charger with your phone.

1.Plug the Travel Charger into a wall outlet.

2.Plug the other end into the Travel Charger into the bottom of your phone, with the battery installed.

Charging when your phone is turned on:

The battery icon appears on the display while charging.

The battery icon turns to when charging is complete.

Charging when your phone is turned off:

The battery icon appears, and the message “BATTERY CHARGING-Power Off-” is shown on the display while charging. When the battery is completely discharged, you may wait for several minutes until the message is shown on the display. The battery icon

turns to , and message changes to “CHARGING COMPLETE- Power Off-” when charging complete.

It takes approximately 3.0 hours to fully recharge a completely rundown battery. With the Sprint-approved LiIon battery, it is okay to recharge the battery before it becomes completely run down.

Section 2: Understanding Your Phone

Displaying Your Phone Number

Just in case you forget your phone number, your PCS Phone can remind you.

To display your phone number:

1.From the Standby mode, press to display the main menu.

2.Highlight Phone Info and press .

3.Highlight My Phone# and press .

Making and Answering Calls

Making Calls

Your PCS Phone offers many different ways to make calls, including

PCS Voice CommandSM (pages 167-169),Speed Dialing (pages 88-89)and using Call History (pages 69-73).

To make a call using your keypad:

1.Make sure your phone is on.

2.Enter a phone number. (If you make a mistake while dialing,

press to erase one digit at a time. Press and hold to erase the entire number.)

3.Press (To make a call when you are roaming and Call Guard is

enabled, press , highlight Roam Call and press .)

4.When you’re finished, press .

Tip: To redial your last outgoing call, press twice.

Tip: When making calls off the enhanced Sprint Nationwide PCS Network, always dial using 11 digits (1 + area code + phone number).

Section 2: Understanding Your Phone

20 2A: Your PCS Phone – The Basics 2A: Your PCS Phone – The Basics 21