SETTINGS FOR RS485 TERMINALS USE
The VCR can be controlled through a special controller connected to the RS485 terminal.
If the VCR is going to be controlled trough a connection to the RS485 terminals, be sure to first make the settings below.
1Press the MENU button until the (SET UP 5) menu is displayed.
@@@@@@@<SET@UP@5>
2Press the ] button, until the “ADDRESS” setting is flashing.
3Press the l (or j) button to set the VCR address.
NOTES:
•The address can be set between 000 and 127.
•Keep the button pressed and the setting will change rapidly.
4Press the ] button, until the “TERMINATE” setting is flashing.
5Press the l (or j) button to set the termination.
N. . . . . . . . . . Not terminated Y . . . . . . . . . . Terminated
6Press the ] button, until the “DATA SPEED” setting is flashing.
7Press the l (or j) button to set the data transfer speed.
8Press the ] button, until the “STATUS INFO” setting is flashing.
9Press the l (or j) button to set the desired setting.
Y. . . . . . . . . . . The VCR status information (state information and warning state) and mode changes are output at the RS485 terminal.
N. . . . . . . . . . . The VCR status information (state information and warning state) and mode changes are not output at the RS485 terminal.
NOTE:
•The warning state information output (sent) will depend on the settings for WARN. OUT in the (SETUP 5) menu.
FPress the ] button, until the “ALARM INFO” setting is flashing.
GPress the l (or j) button to set the desired setting.
Y. . . . . . . . . . . The VCR alarm information (alarm recording start and stop) and video loss information are output at the RS485 terminal.
N. . . . . . . . . . . The VCR alarm information (alarm recording start and stop) and video loss information are not output at the RS485 terminal.
HPress the PAUSE/SEARCH button to save the settings.
19200
2400
4800
9600
24 | English |