Sanyo VCC-ZM400 ON:, ON:, OFF, OFF:, OFF:, English, 4DNR setting, 5BURST setting, 6FOCUS setting, Available settings:, Available settings:, Available settings:

LENS SETTING (LENS)

English

3	D/N SETTING - AUTO		4	D/N SETTING - AUTO
	AGC MAX GAIN	+9·		AGC MAX GAIN	+9·
	DNR	OFF		DNR	ON
	BURST	OFF		BURST	OFF
	FOCUS	1		FOCUS	1
	LEVEL	MID		LEVEL	MID
	PRESET	OFF		PRESET	OFF
	MENU	BACK		MENU	BACK

3AGC MAX GAIN setting

Use the cursor button (j or l) to move the cursor to AGC MAX GAIN, and then use the cursor button (d or c) to select the gain.

Available settings: Select the maximum AGC gain from +9dB, +12dB or +15dB.

4DNR setting

Use the cursor button (j or l) to move the cursor to DNR, and then use the cursor button (d or c) to select the digital noise reduction setting (e.g. ON).

Available settings:

•ON: DNR (digital noise reduction) is applied. This reduces interference at low luminance levels.

•OFF: DNR is not applied.

Note: Digital noise reduction operates when the gain control increases. In addition, blurring and ghosting of images can occur when moving images are being monitored, and so the resolution is also reduced slightly.

5	D/N SETTING - AUTO		6	D/N SETTING - AUTO
	AGC MAX GAIN	+9·		AGC MAX GAIN	+9·
	DNR	ON		DNR	ON
	BURST	ON		BURST	ON
	FOCUS	1		FOCUS	1
	LEVEL	MID		LEVEL	MID
	PRESET	OFF		PRESET	OFF
	MENU	BACK		MENU	BACK

5BURST setting

Use the cursor button (j or l) to move the cursor to BURST, and then use the cursor button (d or c) to select the burst setting (e.g. ON).

Available settings:

•ON: The color burst signal is turned on.

•OFF: This should normally be set to “OFF”.

6FOCUS setting

Use the cursor button (j or l) to move the cursor to FOCUS, and then use the cursor button (d or c) to select the focus setting (e.g. 1).

Available settings:

•1: Near-infrared wavelength correction is set. (around 900 nm)

•2: Visible light spectrum is set.

Note: This is set to “1” at the time of shipment from the factory. If the images are out of focus, change it to “2”.

25