Sanyo VCC-ZM400 ON, English, ☞SMART ATW setting, Use the cursor button

VIEW SETTING

3 ATW MASKING ATW MASKING

CONTINUE (ñ) CONTINUE (ñ)

3Use the cursor button (j l d c) to move the mask pattern over the bright light source, then press the SET button.

Use the same steps to place addition masks as needed.

Note: Initial settings place no masks on the screen. To cancel the placement of masks, press the SET button again.

4Use the cursor button (j or l) to move a mask pattern to the bottom area of the screen and continue holding the cursor button straight down for 3 seconds.

The PRESET and MENU items will appear on the screen. Use the cursor button (j or l) to select BACK, then press the SET button. The ATW SETTING screen will reappear.

☞To close the menu screen or return to the previous screen, select BACK or END for MENU and press the SET button.

4	ATW SETTING		5	ATW SETTING
	MASKING	ON ‚		MASKING	ON ‚
	SMART ATW	OFF		SMART ATW	ON
	PRESET	OFF		PRESET	OFF
	MENU	BACK		MENU	BACK

☞SMART ATW setting

If saturation is high or a scene is bright, the most suitable colors may not be obtained. In this case, set the SMART ATW to ON.

5Use the cursor button (j or l) to move the cursor to SMART ATW, then use the cursor button (d or c) to set

ON.

☞To close the menu screen or return to the previous screen, select BACK or END for MENU and press the SET button.

English

44