Savin 2712, 2212 When Memory Reaches 0%, To Remove Paper from the Staple Unit, To resume scanning

Copying

To Stop Scanning Temporarily

When you are using the Sort, Stack, or Staple function, the originals are scanned into memory.

APress the {Clear/Stop} key to stop

2 originals from being scanned into memory.

To resume scanning

APress the [No] key to resume scanning.

Note

❒Scanned images in memory are not cleared.

To clear scanned images of the originals

APress the [Yes] key.

Scanning is stopped with the images cleared.

When Memory Reaches 0%

Scanning will be stopped if the size of scanned image data exceeds memory capacity.

Note

❒There is enough memory to store

approximate 1,000 originals of A4, 81/2" ⋅ 11" size. The number of originals that can be stored in memory varies depending on the memory setting and original type. In addition, the number of origi- nals that can be stored in memory will be reduced when you use oth- er functions.

Reference

Scanning will stop when memory reaches 0% during sorted copying. However, you can change this set- ting so that all the scanned pages are copied and delivered to the tray. After which, the machine au- tomatically continues scanning the remaining originals. ⇒ "Memory Full Auto Scan Restart" on p.204 “Input/Output”

APress the {Start}key.

The scanned pages are delivered to the tray. Then, the image data in memory is cleared.

BRemove the copies and continue copying by following the instruc- tions on the display.

To Remove Paper from the Staple Unit

If you cancel a stapling copy job in the middle of the job, paper might be left in the staple unit. In this case, remove the paper from the staple unit.

APress the {Clear Modes}key to can- cel the copy settings.

BPlace the next original, and then press the {Start}key.

The paper left in the staple unit is automatically delivered, and then the next job starts.

Note

❒When paper is not delivered and a message is displayed, fol- low the instructions on the dis- play to remove the paper.

56