PowerLogicTM EM4800 Series |
| |
Safety Precautions |
| 04/2011 |
|
| |
SAFETY PRECAUTIONS | Carefully observe these safety instructions. | |
|
|
|
|
| DANGER |
|
| HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH |
|
| • Apply appropriate personal protective equipment (PPE) and follow |
|
| safe electrical work practices. See NFPA 70E. |
|
| • Only qualified electrical workers should install this equipment. Such |
|
| work should be performed only after reading this entire set of |
|
| instructions. |
|
| • The equipment must be accessible to authorized personnel only. |
|
| Equipment must be installed in areas where access can be |
|
| restricted. |
|
| • NEVER work alone. |
|
| • Before performing visual inspections, tests, or maintenance of this |
|
| equipment, disconnect all sources of electric power. Assume that all |
|
| circuits are live until they have been completely |
|
| tested, and tagged. Pay particular attention to the design of the |
|
| power system. Consider all sources of power, including the |
|
| possibility of backfeeding. |
|
| • Turn off all power supplying the meter and the equipment in which |
|
| it is installed before working on it. |
|
| • Always use a properly rated voltage sensing device to confirm that |
|
| all power is off. |
|
| • Before closing all covers and doors, carefully inspect the work area |
|
| for tools and objects that may have been left inside the equipment. |
|
| • Successful equipment operation requires proper handling, |
|
| installation, and operation. Neglecting fundamental installation |
|
| requirements can lead to personal injury as well as damage to |
|
| electrical equipment or other property. |
|
| • NEVER bypass external fusing. |
|
| • NEVER short the secondary of a Potential Transformer (PT). |
|
| • Always short the secondary of a current transformer prior to |
|
| disconnecting current input loads. |
|
| Failure to follow these instructions will result in death or serious |
|
| injury. |
Electrical Standards Compliance | • | Use the unit only in accordance with the electrical power rating |
| • | The unit is only to be installed by a qualified electrician |
| • | Initial installation of the unit must be inspected by the local electrical |
|
| Inspection Authority |
| • | Install the unit in compliance with the following local and national |
|
| electrical codes: |
|
| • Canada: Canadian Electrical Code, Part I, CSA C22.1 |
|
| • United States: National Fire Protection Association (NFPA) 70; US |
|
| National Electrical Code |
|
| • Elsewhere: International Electrotechnical Commission (IEC) 364, |
|
| Part |
| • | Ensure that the unit is properly earthed |
| • | If the equipment is installed or used in a manner other than that |
|
| specified in this document, it may void your warranty or impair the |
|
| protection of the equipment. |
6 | © 201 Schneider Electric All Rights Reserved |