7.CHARGER FEATURES AND CONTROLS
The NAPA
7.1CONTROL CENTER FEATURES
The Digital Test and
Charge display module displays volts, amps, amp hours, and charge time units as indicated via green LEDs. 
Pass/Fail LEDs indicate test results via a green LED for PASS and a 
red LED for FAIL.
VOLTS | V |
|
|
AMPS. | A |
|
|
Ah |
|
| |
TIME |
|
| SELECT |
TEMPS |
|
| SÉLECT. |
TIEMPO |
|
| SELEC. |
|
|
| |
|
| BAT. START. ALT. | FUNCTION |
|
|
| |
|
| CHARGE CARG | FONCTION |
PASS |
| A | FUNCTIÓN |
OK |
| ||
|
| ||
FAIL |
|
|
|
|
| TEST / PRUEBA |
|
Control Center Panel
The Select button gives the user the ability to select the display out- puts, depending on what is desired.
The Function button allows users to change the operation from Charging to test modes (Battery Charge Acceptance, Starter, or Alternator test).
NOTE: The
As an AMMETER, it indicates the amount of amps flowing from charger into battery.
It keeps track of all accumulated amp hours during a test.
It serves as a VOLTMETER, indicating live voltage as soon as clamps are attached. During TIMER operations, it shows either remaining time or elapsed time.
7.2 TIMER SWITCH
The Timer switch on the
The OFF position disconnects the output of the charger. By rotating the dial clockwise the output is turned ON for a duration of time determined by the number of minutes at which the dial is set. The HOLD function can be used if charging times longer than 120 minutes are required. While in the timing phase, the output can be turned off by rotat- ing the dial counterclockwise to the OFF position.
HOLD | OFF |
ARRÊT | |
CONT. | APAGADA |
ESPERA | 15 MIN |
|
TEST
PRUEBA
120 MIN | 30 MIN |
105 MIN | 45 MIN |
90 MIN | 60 MIN |
| 75 MIN |
Timer Switch
When determining charging time, refer to section 12. If the charger is plugged in when the Timer is set, the internal fan will spin. A faint ticking sound is heard while the Timer runs.
NOTE: There is no sound when the Timer completes, except for a soft click.
▪ ▪
