Transmission Cable Adjustment-SP6213 | Scotts SP6211 guide

SERVICE

Transmission Cable Adjustment—SP6213

CAUTION: Avoid injury! Before removing belt shield:

•Stop engine and wait for all moving parts to stop.

•Prevent burns by allowing engine to cool.

•Disconnect spark plug wire.

•Wear protective gloves when service is performed within the mower blade area.

•DO NOT operate mower without belt shield.

1.Stop engine and disconnect spark plug wire.

B

C

A

M96556

2. Remove hardware (A) and belt shield (B).

CAUTION: Avoid injury! Wear protective eye wear when removing belt from drive sheave. Tension spring may come loose.

NOTE: Transmission cable adjustment can be performed without removing belt and pulley. The belt and pulley have been removed for clarity of pictures.

C

D

M93055

3. Remove control cables (C) from belt shield notch (D).

F

EG

MX1577

4.Push drive sheave (E) forward to relieve spring tension on belt and remove drive belt (F).

5.Remove E-clip (G) and drive sheave.

H

M96828

6.Measure the clutch spring length (H) in the relaxed position. Record this value.

I

M96831

7.Engage the transmission bail (at handle bar) and measure the spring length in the extended position (I).

The spring extension length (the difference between A and B measurements) must be 10 mm (0.390 in.).

Service - 20

Image 24

Scotts SP6211 manual Transmission Cable Adjustment-SP6213

Contents

OPERATOR’S Manual Using Your Operator’s Manual IntroductionThank You for Purchasing a Scotts Product California Proposition 65 Warning Product Identification Record Identification Numbers Table of Contents Safety Safety-Alert SymbolMachine Safety Labels Certification Label Operate Safely Practice Safe Maintenance Protect ChildrenHelp Prevent Serious or Fatal Accidents Before you unplug or adjust machine Avoid Injury from Contacting BladeHandling Waste Products Handling Fuel Safely Operating Engine Controls Handle and Cutting Height ControlsHandle Controls Stop Engine Adjusting Handle Height Key Cutting Height Adjustments In mm InchesUpper Handle Lower Handle Starting Engine RUNNING, Blade is TurningKeep hands, feet and clothing away from the blade Forward Travel Travel SpeedsStopping Engine Using Side Discharge Chute Using Grass BagMowing Tips To Avoid Scalping Bagging and CompostingBagging Tips Mulching Tips After Mowing Replacement Parts Service LiteratureJohn Deere Quality Part Number Service Intervals Service Engine Warranty Maintenance Statement Engine OilAdjusting Carburetor Avoid Fumes Changing Engine Oil To Change Engine OIL from the TOP Cleaning and Replacing Air Cleaner Element To Change Engine OIL from the Bottom Cleaning and Gapping Spark Plug Cleaning Engine Cooling FinsStop engine. Let it cool Cleaning Drive Belt and Transmission Area Checking and Replacing Drive Belt To Replace Drive Belt Picture Note View is from underside of differential Transmission Cable Adjustment-SP6213 Lubricate Drive Shaft Hub Bushings Lubricate Mower Axles Check Blade Sharpening BladeCheck Blade To Remove Blade Balance and Install Blade Filling Fuel Tank Cleaning Fuel Cap Vent Troubleshooting Using Troubleshooting ChartCheck Troubleshooting Storing Safety Storing MachinePreparing Machine for Storage Preparing Fuel and Engine For Storage Remove Mower from Storage Assembly Install Starter RopeLawnmower Assembly Side Discharge Chute Bagger Bagger Chute Identify Parts SP6211 and SP6213 Install Grass Bag Add Engine Oil Insert bagging chute tab E into rear mower shield slot F Test Mower Specifications Machine SpecificationsEngine Travel Speed Range Dimensions Recommended Lubricants Warranty Limited Warranty for NEW Scotts Brand Products Tire Warranty Limited Engine Warranty Warranted Parts Cleaning Belt and Transmission Area Index Quality Statement Step Refer to your operator’s manualStep Contact your dealer Step Call the Customer Communications Center Service Record Record Service Dates