SEAL 6500 owner manual AIR Pressure Gauge, AIR Regulator Knob, U T C H C O N T R O L Pa N E L

C L U T C H C O N T R O L PA N E L

The Clutch Control Panel is located on the left-side cabinet when facing the rear of the laminator. The operator can adjust the amount of tension that is directly applied to the laminate between the main and pull rollers. The amount of tension applied affects the output and extreme pull tension will stretch the hot films causing outfeed waves in the finished product. This is a factor with films such as Print Guard®, which stretches easily. Excessive tension will also cause downward curl in the finished prod- uct. The standard setting for normal operation is 40-60 PSI.

IMPORTANT! Excessive pull clutch tension will cause premature wear to the drive system and may cause damage to the laminator. Use the minimum amount required for the laminating process.

1. AIR PRESSURE GAUGE

Indicates the PSI reading for the pulling tension of the bottom pull roller. The standard setting for normal opera- tion is 40-60 PSI.

2. AIR REGULATOR KNOB

This knob adjusts the pulling tension of the bottom pull roller. Pull out the knob and turn to adjust; push back in to set. Turn clockwise to increase the amount of pull ten- sion and turn counter-clockwise to decrease the amount.

Figure 7. Clutch Control Panel

14