I M P O R TA N T S A F E G U A R D S
SAFETY SYMBOLS USED ON THE LAMINATOR
IMPORTANT! Read and make sure you understand these safety and operating guidelines.
Rotating Parts: Risk of Injury
Failure to use caution near rotating rollers could result in physical injury. Be careful that items such as loose cloth- ing, long hair and jewelry do not become entangled in rotating parts.
The laminator is equipped with photoelectric eyes to pre- vent contact with the rotating rollers. Make sure that these safety provisions are always in operation/installed.
IMPORTANT! The laminator operation will cease immediately when the photoelectric eyes, set directly in the path of the front and back of the rollers, are blocked. THIS WILL NOT HAPPEN when using the footswitch in which case a BUZZER will sound and the laminator runs in slow mode at a rate of
Hot Surface: Risk of Injury on Contact
The laminator contains a heated top- roller, which may reach temperatures of 275°F (135°C). There is a danger of severe burns if the heated
Electrical Parts – Danger of being injured by electricity.
Do not open the locked doors because of the risk of being injured by voltage. Only authorized maintenance and ser- vice technicians or safety personnel should have access to the keys for mechanical upkeep or repair.
WARNING! Make sure the door interlock on the left- side cabinet is disengaged when opening the
IMPORTANT! Do not place heavy objects on the power supply cord.
PREVENTATIVE MEASURES:
Do not feed objects such as staples, paper clips and rough or abrasive materials through the laminating rollers.
Keep all objects, such as tools, rulers, pens, markers or knives away from the roller opening. Refrain from leaving such items on the front table to prevent them from acci- dentally being fed into the rollers.
IMPORTANT! NEVER cut or slice directly on the rollers as any cuts or gouges will destroy them. ALWAYS use cutters with enclosed blades to prevent cutting the rollers and to avoid extensive replacement costs.
WARNING! Always adjust the shim wheels to create a gap between the laminating rollers to prevent flat spots from developing when the laminator is not in use. Flat spots will affect the quality of the output and void the warranty replacement.
IMPORTANT! The main roller should be down and turning while heating up to prevent uneven hot spots on the roller. A stationary roller will develop concen- trated heat in one area, which will damage the roller.
SERVICING AND REPLACEMENT PARTS
Service and maintenance must be performed fully in accordance with the instructions. Servicing by any unauthorized technician voids the warranty. The service technician must use replacement parts specified by SEAL Graphics.
Service Technicians must perform safety checks after completing any service or repairs to the laminator.
9
