E L E C T R I C A L S P E C I F I C AT I O N S

Connect the laminator in accordance with the details given on the identification plate attached to the rear of the laminator. Refer also to the Technical Specifications page for more information.

Single Phase Version:

(Part No. 60424)

For areas where the voltage requirements are

200-240V, the following is applicable:

Power cord:

Earth Ground

3/6 AWG,

Black Wire

Type SOW-A/SO

90 C/194° F, 600 Volts

White Wire

Power Cord Strain Relief:

Turn clockwise to tighten.

Grounding Lug

**IMPORTANT: The ground (green wire) should be two inches longer than the black and white wires

to fit into the grounding lug.

Figure 1. Wiring Diagram

CONNECTING YOUR LAMINATOR

All domestic laminators will be shipped without a power cord. It is required that only a qualified electrician provides power to the laminator or the warranty will be void. We recommend a Ground Fault Interrupter (GFI) circuit breaker with a 60-amp load rating, not exceeding a

100-amp load rating. Use 3/6 AWG power cord, Type SOW-A/SO rated to 90°C/194° F and 600 Volts. See Figure 1 Wiring Diagram for detailed information. For European laminators use a Residual Current Device (RCD/RCCD). Once power is connected to your lamina- tor, press the Stand-By Switch UP on the front control panel to turn the laminator ON. If you have no display, refer to the “Troubleshooting” page for problem-solving information.

WARNING! Any unauthorized changes or modifica- tions to this unit without our prior written approval will void the user’s warranty and will transfer health and safety obligations to the user.

IMPORTANT! SEAL Graphics recommends that a licensed electrician, in accordance with electrical codes in your area, install your mains power. Specifications subject to change without notice.

IMPORTANT! The mains outlet should be fused no higher than 60 Amp, Three-phase -or- 100 Amp, Single-phase.

4

Page 4
Image 4
SEAL 6500 owner manual Connecting Your Laminator, E C T R I C a L S P E C I F I C AT I O N S