basic operation
Always sand outside curves onthe left side ofcenter on
the sanding disc as shown.
WARNING: Applying the workplece to the right side
of the disc could cause workplece to fly up (kick-
back) and result In an Injury.
WORKPIECE
SANDING
DISC

SANDING SMALL END SURFACES ON

THE SANDING DISC

NOTE: Use of a Miter Gauge (optional accessory) is
recommended for this operation.
Always move the work across left side of center on the
sanding disc face as shown,
WARNING: Applying the workpiece to the right side
of the disc first could cause workplece to fly up
(kickback) and result In an Injury.
\\
MITER GAUGE
ACCESSORYI
WORKPIECE
CENTER
WARNING: For yourown safety, turn switch"OFF"
and remove plug from pOwer source outlet before
aajustlng your sander.
NOTE: Use a combination square to square the miter
gauge to the face of the disc (combination _uare must
be "true" -See "Unpacking - Tools Needed" section on
page 6 for checking this rnethod). If itis not square,
loosen the miter gauge knob and move the miter gauge
slightly until it is square. Without moving the miter
gauge, tighten the knob securely,
MITER GAUGE
,ACCESSORY
COMBINATION
SQUARE
Always position the workpiece to the left of center on
sanding disc with disc rotating counterclockwise as
shown,
The table may be tilted for beveled work. \\
CENTER
JWORKPIECE
(LEN OF CENTER)
18