Sears 113.22643 assembly

assembly

INSTALLING SANDING DiSC AND GUARD

1. Locate sanding disc and pee backing from disc.

Alignperimeter of discwith I_late andpress disc firmly

into position all the way around.

2. Locate disc guard and two pan head screws, M4,2 x

1.4-12 from loose Darts bag.

3. Position disc guard against lower 1/3 of disc aligning

holes as shown.

4. Using phillips type screwdriver, fasten the pan head

screws securely applying slight pressure to thread

the holes. SANDING

DiSC

SANDING

PLATE

INSTALLING WORK SUPPORT

1. Locate work support and hex screw M6 x 1,0-14,

washer and Iockwasher.

2. Hold worksupport into position and fasten as shown.

Do not overtighten.

LOCKWASHER =LATWASHER

HEX SCREW WORK SUPPORT

HEX SCREW

WORK SUPPOR]

INSTALLING TABLE ASSEMBLY

1. Locate table support and (3) hex head screws, M6 x

1.0-14. washer and Iockwashers among loose parts.

2. Position table support against table, aligning holes as

shown.

3. Fasten table support to table as shown.

J

HEX HEAD SCREW (3

TABLE

SUPPORT

_WASHER 13)

LOCKWASHER (3)

Contents

Main Save This Manual For Future Reference BELT AND DiSC SANDER FOR YOUR SAFETY: I J _ RS/CRRFTSMRN BELT AND DiSC SANDER assernbly operating orepair parts Sold by SEARS, ROEBUCK AND CO., Chicago, IL. 60684 U.S.A. safety instructions for beUtand isc sander BEFORE USING THE SANDER BEFORE EACH USE: Inspect your sander. HANDS, FACE, EARS. safety instructions for belt and disc sander WHENEVER SANDER motor specifications and electrical requirements / contents unpacking and checking contents TOOLS NEEDED assembJy MOUNTING BELT AND DISC SANDER TO WORKBENCH r ............. h CLAMPING BELT AND DiSC SANDER TO WORKBENCH assembly INSTALLING SANDING DiSC AND GUARD INSTALLING WORK SUPPORT INSTALLING TABLE ASSEMBLY /// assembly AUXILIARY MOUNTING FOR VERTICAL SANDING J f INSTALLING THE SANDING BELT - TENSIONING AND TRACKING Page / ON-OFF SWITCH PLAN AHEAD TO PROTECT YOUR EYES, HANDS, FACE, EARS Dressforsafety, WHENEVER SANDER IS RUNNING i bas c operation BEVEL SANDING SURFACE SANDING ON THE SANDING BELT END SANDING ON THE SANDING BELT SANDING CURVED EDGES basic operation SANDING SMALL END SURFACES ON THE SANDING DISC maintenance LUBRICATION REMOVING PULLEY COVER AND INSTALLING DRIVE BELT maintenance INSTALLING PULLEY COVER troubleshooting sears recommends the following accessories Page repair parts PARTS LiST FOR CRAFTSMAN BELT AND DiSC SANDER MODEL 113.226430 SERVICE MODEL NO. 113.226430 HOW TO ORDER REPAIR PARTS BELTAND DISC SANDER Sold by SEARS, ROEBUCK AND CO., Chicago, IL 60684 U.S.A.