maintenance
4. Slightly tighten (3) screws. Adjust tension ofbelt by
puttingblade screwdriver inadjusting hole. Push up
on screwdriver to tighten tension between pulleys.
5Tighten screws being careful not to disturb belt.
STANDARD
SCREWDRIVER
\
ADJUSTING
HOLE
6. Test belt tension by placing fingers on either side of
belt and squeeze. There should be about a 1/4" give
to the belt.
NOTE: Excessive tightness on pulleybelt may cause
increased noise and overload motor. Excessive loose-
ness on pulley belt maycause belt to fail prematurely.
BELT

INSTALLING PULLEY COVER

1. Locatethe pulley cover and position it inside the relief
edges of pulley housing.
2. Using a phillips screwdriver, reinstall and tighten the
flat head screw. =ULLEY
COVER
2O