Sears 113.22643 ///

4. Locatewasher 6.5x 17.8x 1.6 and knob among loose

pads,

5. Position table support incorresponding holeson side

of base as shown. Make sure the 9.5ram diameter

index pin aligns with upper hole,

6, Place washer on threaded shaft of knob and insert

through slot into threaded holes of base

///

SUPPORT

WARNING: To avoid trapping the work or fingers

between the table and sanding surface, the table

edge should be a maximum of 1/16 inch from sand-

ing surface.

7, Loosen the (3) hex head screws and adjust table. f@

li161NCH MAXIMUM

SURFACE

TABLE

8. Use your Owner's Manual as a spacer. Place ten

pages of the Owner's Manual between the Disc and

the front edge of the table. Hold the table against the

manual and tighten the three (3) Hex Washer Head

screws.

_\_ OWNERS MANUAL

0, i

/'0 0" 10 PAGES

SCALE LABEL TABLE LOCK

KNOB

Contents

Main Save This Manual For Future Reference BELT AND DiSC SANDER FOR YOUR SAFETY: I J _ RS/CRRFTSMRN BELT AND DiSC SANDER assernbly operating orepair parts Sold by SEARS, ROEBUCK AND CO., Chicago, IL. 60684 U.S.A. safety instructions for beUtand isc sander BEFORE USING THE SANDER BEFORE EACH USE: Inspect your sander. HANDS, FACE, EARS. safety instructions for belt and disc sander WHENEVER SANDER motor specifications and electrical requirements / contents unpacking and checking contents TOOLS NEEDED assembJy MOUNTING BELT AND DISC SANDER TO WORKBENCH r ............. h CLAMPING BELT AND DiSC SANDER TO WORKBENCH assembly INSTALLING SANDING DiSC AND GUARD INSTALLING WORK SUPPORT INSTALLING TABLE ASSEMBLY /// assembly AUXILIARY MOUNTING FOR VERTICAL SANDING J f INSTALLING THE SANDING BELT - TENSIONING AND TRACKING Page / ON-OFF SWITCH PLAN AHEAD TO PROTECT YOUR EYES, HANDS, FACE, EARS Dressforsafety, WHENEVER SANDER IS RUNNING i bas c operation BEVEL SANDING SURFACE SANDING ON THE SANDING BELT END SANDING ON THE SANDING BELT SANDING CURVED EDGES basic operation SANDING SMALL END SURFACES ON THE SANDING DISC maintenance LUBRICATION REMOVING PULLEY COVER AND INSTALLING DRIVE BELT maintenance INSTALLING PULLEY COVER troubleshooting sears recommends the following accessories Page repair parts PARTS LiST FOR CRAFTSMAN BELT AND DiSC SANDER MODEL 113.226430 SERVICE MODEL NO. 113.226430 HOW TO ORDER REPAIR PARTS BELTAND DISC SANDER Sold by SEARS, ROEBUCK AND CO., Chicago, IL 60684 U.S.A.