maintenance
WARNING: For your own safety, turn switch "OFF"
and remove plug from power source outlet before
adjuSting, maintaining, or lubrlcsting your belt and
disc sander.
WARNING: TO avoid electrocution orfire, any re-
pairs to electrical systems should be done only by
qualified service technicians. Unit must be reas-
sembled exactly to factory specifications.
Ifpowercord isworn orcut, ordamaged inanyway, have
itreplaced immediately.
Frequently blow out or vacuum out any dust that may
accumulate inside the motor.
A coat of automobile-type wax applied to the worktable
will make it easier to feed the work while finishing.
Do not apply wax tothe abrasive belt table because the
belt could pick up the wax anddeposit it on the pulleys,
causing the belt to slip.

LUBRICATION

The BALL BEARINGS in this machine are packed with
grease atthe factory. They require no further lubrication.
Sleeve bearings should be lubricated with 30 weight oil
or equivalent after each 10 hours of operation.
BLACK
RE_WHITE 1
BLACK JUMPER POWER CORD
2
WHITE
WIRING DIAGRAM

REMOVING PULLEY COVER AND

INSTALLING DRIVE BELT

1. Using a phillips screwdriver, remove the flat head
screw located inthe middle of the cover.
2. Remove the cover.
PHILLIPS
SCREWDRIVER
PULLEY
COVER
3. Loosen (3) screws to allow pulleys to shift enough to
place belt around them. Place belt around motor
pulley andd rivepulley as shown ifbelt isever broken.
BELT
MOTOR
PULLEY
SCREWS
19