FULLONE YEAR WARRANTY ON CRAFTSMAN BELT AND DISC SANDER
Ifwith In one year from the data ofpurchase, th Is Craftsman BeIt and Disc Sander fails due to a defect in mater lal
or workmanship, Sears will repair it, free of charge.
WARRANTY SERVICE IS AVAILABLE BY SIMPLY CONTACTING THE NEAREST SEARS SERVICE CENTER/
DEPARTMENT THROUGHOUT THE UNITED STATES.
THIS WARRANTY APPLIES ONLY WHILE THIS PRODUCT IS USED iN THE UNITED STATES.
This warranty gives you specific legal rights, and you may also have other rights which vary from state tostate.
SEARS, ROEBUCK AND CO.,698/731A, Sears Tower, Chicago, IL 60684
safety
Safety isa combination of common sense,staying alert
andknowinghow your belt and discsander works. Read
this manualto understandthis sander.
instructions for beUtand isc sander

BEFORE USING THE SANDER

WARNING: To avoid mistakes that could cause
serious, permanent injury, do ROtplug the sander in
until the following steps are completed.
WHEN INSTALLING OR MOVING THE
SANDER
AVOID DANGEROUS ENVIRONMENT. Usethesander
inadry, indoor place protected from rain. Keepwork
area well lighted.
Placethe sander soneitherthe usernor bystanders are
forced to stand in linewith the abrasive beltor disc,
Assembly and alignment. (See pages7-11) To avoid injury from unexpected sander movement:
Learn the use and function of theON-OFF switch,
backstop, belt tracking knob,belt tension lever, work
table and worktable tiltlock knob. (See pages 12-13)
Review and understanding of all safety instructions
and operating procedures in this manual.
•Review ofthe maintenance methods for this sander.
(See pages 19 - 20)
Read thefollowing WARNING label found on the frontof
the sander:
Always unplugthe sander before moving it.
Putthe sander on afirm level surface where there is
plenty of room for handling and properly supporting
the workpiece
• Support the sander so it does not rock.
Boltthe sander to its work surface. Usethe fasteners
and method shown in "Assembly and Alignment."
• (Page 7)
NEVER STAND ON TOOL. Serious injury could
occurif the tool tips. Do not store anything above or
nearthe tool where anyone might stand on the tool to
reachthem.
To avoid injury or death from electrical shock:
•GROUND THE SANDER. This sander has an ap-
proved 3-conductor cord and a 3-prong grounding
type plug. Use only 3-wire, grounded outlets rated
120 volts, 15 amperes (amps). The green conductor
inthe cord is the grounding wire. To avoid electrocu-
tion, N EVER connect thegreen wire to a live terminal.
Make sure your fingers do not touch the plug's metal
prongs when plugging or unplugging the sander,