Sears 113.22643 unpacking and checking contents

POWER TOOL WARRANTY ......................... 2

SAFETY INSTRUCTIONS FOR

BELT D)SC SANDEF ............................................. 2

MOTOR SPECIFICATIONS AND

ELECTRICAL REQUIREMENTS ........................... 5

UNPACKING AND CHECKING CONTENTS ............ 6

ASSEMBLY ................................................................ 7

Mounting Belt and Disc Sander

to Workbench .................................................... 7

Clamping Belt and Disc Sander

toWorkbench .................................................... 7

Installing Sanding Disc and Guard ........................ 8

Installing Backstop ................................................. 8

Installing Table Assembly ...................................... 8

Auxilliary Mounting for Vertical Sanding .............. 10

Squaring Table Assembly .................................... 10

Installing the Sanding Belt -Tensioning

and Tracking .................................................... 10

GETTING TO KNOW YOUR

BELT AND DISC SANDER .................................. 12

On-Off Switch ....................................................... 13

BASIC OPERATION ............................................ 14

Bevel Sanding ...................................................... 16

Positioning Belt Table .......................................... 16

Surface Sanding on Sanding Belt........................ 17

End Sanding on the Sanding Belt ........................ 17

Sanding Curved Edges ........................................ 17

Sanding Small End Surfaces ............................... 18

MAINTENANCE ....................................................... 19

Lubrication .......................................................... 19

Removing Pulley Cover and

Installing Timing Belt ............................... 19

Installing Pulley Cover ......................................... 20

TROUBLESHOOTING ............................................ 21

RECOMMENDED ACCESSORIES ........................ 21

REPAIR PARTS ....................................................... 22

unpacking and checking contents

TOOLS NEEDED

_OMMWRENCH

COMBINATION SQUARE

PHILLIPS TYPE

SCREWDRIVER 6M_ HE;( "L" WRENCH

STANDARD

SCREWDRIVER

COMBINATION SQUARE MUST BETRUE

STRAIGHT EDGE OF BOAR_

3/4" THICK. THIS EDGE MUST

DRAW LIGHT LfNE ON 8E pERFECTLY STRAIGHT.

BOARD ALONG THIS EDGE _f

SHOULD BE NOGAP OR (3VERLAP

HERE WHEN SQUARE IS FLIPPED

OVER IN DOT'(lED POSITION,

Model 113.22643 Belt and Disc Sander is shipped

complete inone carton.

Separate all parts from packing materials and check

each item with illustration and 'qable of Loose Parts."

NOTE: Make certain all items are accounted for, before

discarding any packing material.

WARNING: To avoid injury, if any parts are missing,

do notattempt to assemblethe Belt and Disc Sander,

plug Inthe power cord, or turn the switch on untilthe

missing parts are obtained and installed correctly.

WARNING: Foryourownsafety, neverconnect plug

to power source outlet, or insert switch key until all

assembly steps are complete and until you have

read and understood the entire owners manual,

ITEM TABLE OF LOOSE PARTS

A Belt and Disc Sander Assembly

B Owner's Manual

C Table

D Sanding Disc

E Table Support

F Guard Disc

G Work Support

H Bag Assembly

Containing the following parts:

Knob

Washer, 6.5 x 17.8 x 1.6

Screw, Pan Hd. TY "AB"

M4.2 x 1.9-12

Switch Key

Lockwasher, Ext. M6

Scale Label

Screw, Hex Hd. M6 x 1.0-14

Hex "L" Wrench 6mm

QTY.