assembly

NOTE: When using motors which have 1/2 in. dia. shafts, place the adapter sleeve (furnished with the motor) on the shaft so that the slot in the sleeve is over the flat spot.

4.Insert the shaft key (furnished with motor) into the grooves in the shaft and pulley so that the end of the key is even with the end of the shaft,

5, Tighten the set screw. Use a pair of pliers on the short end of the set screw wrench for increasedleverage.

MOUNTING THE MOTOR

1.Position the motor mount as shown and place the motor on top of it.

2, Find four 5/16 in.--18 x 3/4 in. CARRIAGE BOLTS, flat washers and hex. nuts. among the loose parts.

3.Insert the bolts as shown .,. install washers . .. screw on nuts but DON'T TIGHTEN them.

4.Using a 5/32 inch set screw wrench unscrew the PIVOT screws as shown.

3/16 x 3/16 KEY

FLAT SPOT

I

ii

II

I

1/2 IN. DIA.

SLEEVE

MOTOR SHAFT

3/4 IN.

BOLT

Oplvosc :Ew

I0

Page 10
Image 10
Sears 113.24611 manual Mounting the Motor, Bolt, Flat Spot, Sleeve