assembly

INSTALLING THE DEPTH STOP

 

1. Screw the THUMB SCREW partways into the DEPTH

 

POINTER.

2. Place the DEPTH POINTER SHOE inside the pointer.

3. Loosen QUILL LOCK HANDLE ... lower the quill

 

about two inches.

4.

Slide the pointer and shoe onto the FEED STOP ROD

 

 

and tighten the thumb screw. Make sure the pointer is

FEED STOP

ROD

DEPTH

POINTER

DEPTH

STOP

positioned

as shown.

SHOE

SCREW

5.

Screw the FEED STOP NUT onto the top of the feed

 

 

stop rod.

6.

Move the pointer upwards against the nut and tighten the thumb screvv.

7.Tighten QU_LL LOCi< HANE_LE.

QUILL LOCK

HANDLE

TABLE LOCK HANDLE

(RIGHT HAND SIDE)

RAISING THE HEAD

-1.Loosen the TABLE LOCK HANDLE.

Z

Place a piece of WOOD on the table. USE THE packing block.

3.Turn the CHUCK SLEEVE until the jaws are all the way up inside the chuck.

4.Raise the table until the wood block touches the chuck body.

5.Tighten the Table Lock Handle.

6.Locate the two clamps and bolts that you removed

from the paper tube when you first started unpacking your drill press.

These parts make up the TABLE SUPPORT COLLAR. Position the TABLE SUPPORT COLLAR underneath the table and tighten the bolts.

7.Loosen the HEAD LOCK HANDLE.

8.Loosen the QUILL LOCK HAND LE.

QUILL LOCK

HANDLE

HEAD

LOCK HANDLE

PIECE OF

WOOD

TABLE SUPPORT

COLLAR

Page 8
Image 8
Sears 113.24611 Assembly, Installing the Depth Stop, Place the Depth Pointer Shoe inside the pointer, About two inches