Sears 113.24611 manual Excessive Tightness could Bend the Motor Mount, Cord TIE

5, Remove the belt guard by "pushing in" on the two "'links".

6.Place motor on drill press ... screw the pivot screws into the holes.

NOTE: DO NOT SCREW THEM IN TOO TIGHT ...

EXCESSIVE TIGHTNESS COULD BEND THE MOTOR MOUNT.

i

7.Find two 5/16 in-18 hex. nuts among the loose parts

.., screw them on to the pivot screws ... tighten

them with a 1/2 in. wrench while preventing the pivot screws from turning.

8.Plug motor cord into outlet inside of dirll press.

9.Find the plastic CORD TIE among the loose parts ...

insert the pointed end into the hole in the motor mount.

10, Gather up the slack in the motor cord ... wrap the CORD TIE around it. •. insert one end of the TIE into

the hole in the other end. Pull it tightly to secure the cord to the motor mount.

CAUTION: If you are using a DOUBLE SHAFT motor.

Make sure the SHAFT PROTECTOR is installed. NEVER

USE THE DRILL PRESS WITH THE UNUSED SHAFT

EXPOSED.

CORD TIE