diustments
WARNeNG: FOR YOUR OWN SAFETY TURN SWITCH "OFF" AND REMOVE PLUG FROM POWER SOURCE OUTLET BEFORE MAKING ANY ADJUSTMENTS.
DEPTH SCALE
When the quill is in the UPPERMOST position, the top
SURFACE OF THE FEED STOP POINTER should be in line with "0" graduation on the DEPTH SCALE.
If it is not ... LOOSEN both mounting screws and reposition the scale.
QUILL RETURN SPRING
If the quill does not return to its UPPERMOST position
when the quill !ock is UNLOCKED ,.. or if the return
action is SLUGGISH ... the SPRING TENSION must be increased.
1. Move DEPTH POINTER to uppermost position and lock it in place.
2.Lock the quill in the uppermost position.
3.GRASP the HUB ... pull it straight out until it is free to turn.
4.Rotate hub TOWARD you about 1/4 turn and PUSH it back in place. This will WIND UP the spring.
5.Unlock quill °.. check tension ... if more is required, repeat steps 2, 3, 4, and 5.
TABLE AND HEAD LOCK HANDLES
The lock handles can be adjusted to make them more convenient to operate.
t.Make sure the support collar is locked in position below the table or the head.
2.Unscrew the lock handle and push the barrel lock out of the hole.
3.Rotate the barrel lock 180 ° , replace it in the hole and screw in the handle.
NOTE: The HEADLOCK HANDLE is located on the LEFT side of the head.
QUILL BEARING ADJUSTMENT
The front of the head is "Split" which permits an
adjustment to be made as the quill and the quill bearing surfaces inside of the head become worn after an extended period of use. The front of the head can be SQUEEZED together or SPREAD apart by adjusting three screws.
1.TIGHTEN quill lock handle.
2.LOOSEN setscrew "A" using a 5/32 in. setscrew wrench.
3, Rotating the eccentric BUSHING "B" in either
direction will move the pinion shaft TOWARD or AWAY from the quill.
With a large pair of pliers, rotate bushing so that pinion shaft moves AWAY from quill.
4.LOOSEN quill lock handte.
U
QUILL RETURN SPRING
HUB
t
,FEED
TABLE LOCK HANDLE HANDLE
TABLE LOCK
HANDLE
BARREL LOCK
BELT TENSION
Refer to section "Getting To Know Your Driit Press" . . .
BELT TENSIONING ROD.
QUILL |
|
LOCK |
|
HANDLE | ECCENTRIC BUSHING "Bi' |
| FIBER WASHER |
SPLIT |
|
SET SCREW "A"
!7
