PERFORMANCE FEATURES
WARNING
CHECK BAG iNDiCATOR
Personal injury Hazard
When the vacuum
CHECK BAG
Always turn off and unplug the vacuum
cleaner before cleaning the agitator area as agitator may suddenly restart. Failure
to do so can result in personal injury.
OVERLOAD PROTECTOR
The PowerMate Overload Protector/
has | Belt Reset | ||
protection |
| against | |
motor | and | beff | |
damage | should | ||
the agitator | jam. | ||
if the | agitator | ||
slows | down | or | |
stops, | the |
|
|
overload | protector | ||
shuts | off | the | |
PowerMate and the red light will come on. The canister motor will continue to run.
To correct problem: Turn off and unplug vacuum cleaner, remove obstruction, then press BELT RESET button.
If the problem persists, have the vacuum cleaner serviced by a Sears or other qualified service agent.
EDGE CLEANER
Active brush edge [ [[
cleaners are on both
sides of the PowerMate. Guide either side of the
PowerMate along
to furniture to help remove dirt trapped at carpet edges.
cleaner | is running | ||
with | normal | indicator _._ | |
airflow, | the | light on | |
the | CHECK | BAG | |
indicator is off.
The light comes on whenever the
airflow becomes blocked, if that
occurs, check the disposable dust bag, motor safety filter and other possible
clog locations shown in HOW YOUR
VACUUM CLEANERWORKS.
To correct problem: See the TROUBLE= SHOOTING table.
NOTE: The light may come on when using certain attachments, due to reduced airflow
through attachment.
THERMAL PROTECTOR
This vacuum cleaner has a thermal protector which automatically trips to protect the vacuum cleaner from overheating. If a clog prevents the normal flow of air to the motor, the thermal protector turns the motor off automatically. This allows the motor to coo[ in order to prevent possible damage to the vacuum cleaner.
To correct problem: Turn off and unplug vacuum cleaner to allow the vacuum
cleaner to cool and the thermal protector to reset. Check for and remove clogs, if necessary. Also check and replace any clogged filters. Wait approximately thirty
(30)minutes and plug the vacuum cleaner in and turn back on to see if the
motor protector has reset.
