Sears 116.28014 manual Dirt Sensor, To Clean the Lenses

				_	4. Replace			the
					exhaust		filter
					cartridge.			Place	6. While
					the	new	filter		holding	latch
					into the		canister		down	rotate
					with	the	foam		filter cover into
					seal	towards		the	place.
					canister.
5. To		replace		the				7. Release latch and verify that filter cover
								is locked	into place.
exhaust			filter
cover		place		the
two	tabs		on	the
filter		cover		into
the	slots		on	the

canister.

DIRT SENSOR

Although the dirt sensor feature in your Kenmore canister is designed for years of trouble free use,the passage of dirt through the air passage system can coat the lens causing the green light to come on and stay on - never switching to red. When this happens the lensesmust be cleaned.

Approx.

5inches (130 turn)

CAUTION

when cleaning the lenses. The residue of

the water or cleaners will accelerate the

Neverrecoatinguse ofwaterthe lensesor anyandcleaningmake solutioncleaning

necessary sooner.

TO CLEAN THE LENSES

. Remove the

handle by

pressing the

handle quick release button.

-_ Sensor

Lenses

2.As indicated by the illustration, the two dirt sensor lenses are located on the inside of the

handle, approximately 5 inches/]30 mm down (note the arrows). These lenses should be cleaned periodically. To reach the sensor lenses, use a small brush such as a bottle brush. Brush each sensor lens several times to remove dust and dirt.

-19-