TOCLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacu- um cleaner, the agitator must be cleaned every time the belt is changed.
The agitator must also be cleaned accord- ing to the following schedule:
Vacuum | Cleaner Use | Clean | Agitator | ||
HEAVY |
| - |
| every | week |
(used | doily) |
|
| ||
MODERATE | - | every | month | ||
(used | times/week) |
|
| ||
LIGHT | - |
|
| every | 2 months |
(used | ] | time/week) |
|
| |
IMPORTANT
Turn off and unplug vacuum cleaner from
electrical outlet. Check and remove hair, string and lint
Remove any dirt or debris in the belt path area or in the brush roller area.
Carefully remove any string or debris located on the agitator or end caps.
AGITATOR ASSEMBLY
n n_ Belt Path_ |
,°0d
TO REPLACE BELT
1. Install new |
|
| |
belt | over |
| for |
|
|
| |
motor | drive, |
|
|
then | over |
| ire |
belt | path. |
|
|
| \ | \ | Path |
| Agitator | End Cap |
|
NOTE: See PARTS AND FEATURES for Belt number.
2. Place agitator
assembly back into PowerMate.
cover and agitator
(2)screws. replace two
4.Line up front of cover and base. Rest cover on front edge of base as shown.
5.Rotate cover back. Press cover firmly until side latches snap into place.
Make sure there is no gap between the cover and base.
6.Turn PowerMateupside down and replace five (5) cover screws.
ZInsert floor brush into PowerMate until floor brush locks
into place.
