ASSEMBLY
INSTALLING BATTERY PACK
See Figure 3.
NOTE: Battery pack is shipped in a low charge condition. Therefore, it must be charged prior to use. Refer to
page 13, “CHARGING BATTERY PACK” for charging
instructions.
nPlace battery pack in your saw. Align raised rib on battery pack with groove inside saw, then slide battery pack in saw as shown in figure 5.
nMake sure the latches on each side of your battery pack snap into place and battery pack is secured in saw before beginning operation.
CAUTION: When placing battery pack in your saw, be sure raised rib on battery pack aligns with groove inside saw and latches snap into place properly.
Improper assembly can cause damage to saw and battery pack.
LATCHES
BATTERY PACK | Fig. 3 |
ATTACHING BLADE
See Figure 4.
WARNING: A
nRemove battery pack from saw.
nLocate latches on side of battery pack and depress to release battery pack from your saw.
nRemove blade wrench (6 mm hex key) from storage area.
nDepress spindle lock button and remove blade screw and outer blade washer.
NOTE: Turn blade screw clockwise to remove.
nWipe a drop of oil onto inner blade washer and outer blade washer where they contact blade.
WARNING: If inner blade washer has been re- moved, replace it before placing blade on spindle. Failure to do so could cause an accident since blade
will not tighten properly.
nFit saw blade inside lower blade guard and onto spindle.
NOTE: The saw teeth point upward at the front of saw as shown in figure 3.
nReplace outer blade washer.
nDepress spindle lock button, then replace blade screw. Tighten blade screw securely.
NOTE: Turn blade screw counterclockwise to tighten.
nReturn blade wrench to storage area.
NOTE: Never use a blade that is too thick to allow the outer blade washer to engage with the flats on the spindle.
SPINDLE
LOCK BUTTON
LOWER BLADE
GUARD HANDLE
SPINDLE
BLADE
� � � �
�� |
� |
� |
�
�
�
� ��
� |
�
INNER
BLADE WASHER
OUTER
BLADE WASHER
BLADE SCREW
Fig. 4
11
