OPERATION

BASE (SHOE) ASSEMBLY

See Figure 5.

The base assembly of your reciprocating saw pivots up and down in both directions. It also is adjustable, allowing the use of the blade teeth at different positions on the blade.

TO CHANGE POSITIONS OF BASE ASSEMBLY:

nRemove battery pack.

WARNING: Failure to remove battery pack from saw could result in accidental starting causing possible serious personal injury.

nLoosen the set screw in the gear frame with the hex key provided with this saw.

nReposition base assembly to desired position.

nRetighten set screw securely. Do not overtighten screw or use an aid with the hex key.

nRemove hex key and store it in the hex key holder.

PIVOT

 

BASE (SHOE)

HEX KEY

ASSEMBLY

SET SCREW

Fig. 5

GENERAL CUTTING

See Figure 6.

Hold your saw firmly in front of and clearly away from you. Make sure saw blade is clear of any foreign material. Be sure material to be cut is held firmly. Small work pieces should be securely clamped in a vise or with clamps

to the work bench or table. Mark the line of cut clearly. Depress the lock-off button, then pull switch trigger to start the cutting action. Place the base assembly against the work, then move the blade into the work. Do not force. Use only enough pressure to keep the saw cutting. Let the blade and saw do the work. Use of excessive pressure that causes bending or twisting of the blade may result in broken blades.

Fig. 6

13

Page 59
Image 59
Sears 315.11485 manual Base Shoe Assembly, To Change Positions of Base Assembly, General Cutting, Pivot, SET Screw