HP 100 CE866A manual Fuser delivery assembly, Position the fuser pressure roller for removal

Fuser delivery assembly

NOTE: For this product, the fuser and the paper delivery components are one assembly.

Position the fuser pressure roller for removal

You must rotate the pressure roller to the correct position before removing the fuser delivery assembly.

1.When the product is in the Ready state, press and hold the Auto-On/Auto-Off (power) button for about seven seconds or until you hear subtle movement within the product and the Ready light turns off.

2.Release the Auto-On/Auto-Off (power) button. The product power will be off and the fuser pressure roller is in the removal position. Unplug the product before removing any components.

NOTE: If you have not removed the image drum before servicing the product, remove it now. See Imaging drum on page 9.

Before proceeding, remove the following components:

●Right cover. See Right cover on page 16

●Left cover. See Left cover on page 17.

●Document feeder. See Document feeder on page 18.

●Document feeder hinges. See Document feeder hinges on page 21.

●Top door, rear-top cover, and delivery cover. See Top door, rear-top cover, and delivery cover on page 22.

●Rear door. See Rear door assembly on page 27.

●Rear-lower cover. See Rear-lower cover on page 28.

●Formatter PCA or formatter and wireless PCA. See Formatter PCA (base model) on page 38 or Formatter and wireless PCA (plus model) on page 40.

ENWW Removal and replacement procedures 53