
Pickup roller
Before proceeding, remove the following components:
●Separation pad assembly. See Separation pad assembly on page 13.
●Right cover assembly. See Right cover on page 16.
●Left cover assembly. See Left cover on page 17.
Rotate the pickup roller to the service position
To gain access to the roller locking tabs you must rotate the roller to the correct position for removal.
1.When the product is in the Ready state, press and hold the
TIP: Optionally, unplug the power cord, and then plug the cord back in.
2.Make sure that one sheet of paper is loaded in the input tray.
NOTE: If more than one sheet of paper is loaded in the tray, this procedure will not be successful.
3.Press and release the
NOTE: Immediately after the
4.When the product finishes initializing, the roller rotates into the removal position. Turn the product off. Unplug the product before removing any components.
NOTE: When the roller is in the removal position, the sheet of paper will have been pulled into the paper path by about 12 mm (.5 in). This is visual confirmation that the roller has rotated to the removal position.
14 Chapter 1 Removal and replacement | ENWW |