2.Remove five screws (callout 1), and then separate the sheet-metal plate (callout 2) and fuser power supply (callout 3) from the product.

CAUTION: The sheet-metal plate and fuser power supply assembly is still attached to the product by a FFC connected to the engine controller assembly. Do not attempt to completely remove the assembly.

Figure 1-49Remove the ITB assembly (2 of 17)

1

2

3

3.Disconnect one FFC (Callout 1), and then remove the sheet-metal plate and fuser power supply assembly.

Figure 1-50Remove the ITB assembly (3 of 17)

1

44 Chapter 1 Removal and replacement

ENWW