2.Remove five screws (callout 1), and then separate the sheet-metal plate (callout 2) and fuser power supply (callout 3) from the product.

CAUTION: The sheet-metal plate and fuser power supply assembly is still attached to the product by a FFC connected to the engine controller assembly. Do not attempt to completely remove the assembly.

Figure 1-82Remove the low-voltage power supply assembly (2 of 9)

1

2

3

3.Disconnect one FFC (Callout 1), and then remove the sheet-metal plate and fuser power supply assembly.

Figure 1-83Remove the low-voltage power supply assembly (3 of 9)

1

64 Chapter 1 Removal and replacement

ENWW