6.Place the product rear-side up, and then remove four screws (callout 1). Figure 1-86Remove the low-voltage power supply assembly (6 of 9)

1

7.Remove three screws (callout 1), disconnect one connector (callout 2) and separate the low- voltage power supply assembly (callout 3) from the product.

CAUTION: Do not attempt to completely remove the low-voltage power supply. The power supply is still connected to the product by three internal connectors.

Figure 1-87Remove the low voltage power supply assembly (7 of 9)

2 3

1

66 Chapter 1 Removal and replacement

ENWW